50% OFF STOREWIDE ENDS SOON SHOP THE SALE
Free Tracked Shipping Worldwide
May 09, 2021 2 min read
Plug-and-play compatibility with electronic appliances, devices, automobiles, etc; indeed helps with the connectivity issues, but to use it you also have to know how to remove the wire from a push-in connector, and it can be a tricky job.
If a wire gets loose or a connector falls off, it’s time to replace it! For a proper guideline on how to remove the wire from a push-in terminal wire block connector keep reading this article, it will also help you if you want to know if you can reuse the wires or release them.
Besides, this article will also cover some basic information about the push-in connectors that you will need to know before anything.
What is a push-in terminal wire block connector?
Human life has become much more manageable with the help of technology and innovation. Push-in connectors are a new type of connectors that makes wiring easier.
Just strip a minimal amount of insulation from the wire and attach it to the connector holes. When the wire is in the correct place; lock it. You can easily connect multiple electrical wiring connections in the connector.
Surprisingly, the push-in connector can also handle #12 gauge solid and other stranded wires.
What is the benefit of a push-in connector?
The push-in connector is fast, reliable, and easy to use. It is used to distribute the conductor in electrical housing applications. In addition to this, it provides a typical range of housing tension of up to 450 volts. However, the input depends upon the high flexibility and number of poles used.
How to release the wires from a push-in connector?
If you’ve ever been faced with a tangled and stuck wire, you’ve probably wondered how to release a push-in wire connector. Removing the wires from a push-in connector; is not a difficult task. However, it is a bit tricky. The connector has a small barb; and once the wire is inserted, the barb goes down.
The key is to push up the barb and take the wire out. Take a thin & round hollow tube with a handle; the tube should fit over the pin. Slide the pin into the hole from the front of the push-in connector; once it’s pushed, the barb will come on the upper side.
You can also check a video on how to release the wires here.
You can also use an alternative method. Just take a small screwdriver and push the barb down. However, make sure that you don’t apply much pressure; the barb should not bend. Also, make sure that you turn off the power; before inserting a screwdriver into the hole.
Can you reuse push-in wire connectors?
If you have previously used solid wire in your push-in connector; only then you can reuse it. Do not reuse the connectors if it contains stranded wire. Moreover, if you feel that; the connector cannot hold any other wire, do not try as it will damage your wire and some types can even crack when re-used.