
AS FEATURED IN
Every. Single. Job.
Sound familiar?
Stop working with a flashlight in your mouth.
Under the hood, under the dash, behind the panel. You need both hands on the job and light right where you’re looking. A flashlight gives you one or the other.
- One hand stuck holding the light
- Jaw aching from biting the flashlight
- One tiny hot spot, shadows everywhere else
- Greasy gloves fumbling for the switch
There’s a better way. ↓
How it works
Hands-free light in 3 simple steps
-
1
Put them on
The light sits right at eye level, so it shines exactly where you look.
-
2
Wave to switch on
A quick wave turns it on or off. No fumbling for buttons, even with greasy gloves.
-
3
Work with both hands
The 230° wide beam lights the whole area. The side spotlight picks out the detail.
Why hold a flashlight at all?
A Flashlight
Frequently Asked Questions
You have two ways. Wave your hand in front of the sensor to switch it on or off hands-free. Or press the button on the side module for manual control. The motion sensor works even with dirty, wet or gloved hands.
The main 800-lumen COB light bar spreads a 230° wide beam across your whole work area. A separate side spotlight focuses light exactly where you need it.
Up to 8 hours on the low setting. Higher brightness settings will run for less time.
Plug it in with the included USB-C cable. A full charge takes about 2–3 hours.
You get the BeamSight LED Work Glasses, a USB-C charging cable and a protective carry case.
They measure 16 cm wide, 6 cm tall and 8 cm deep (6.3 × 2.36 × 3.15 in).
3–5 business days in the USA, and 7–10 business days everywhere else.
If you are not completely satisfied, we will make it right. Every SolderStick product is covered by a 30-day money-back guarantee, and our support team is there if you need them.