4.6 Stars | 5000+ Reviews
Fork Connector Kit
Fork Connector Kit
Slides under a screw terminal – no need to back the screw all the way out
- Crimps with a standard tool – no heat, no solder
- Nylon insulation sleeve – resists abrasion and moisture
-
Free Worldwide Shipping
-
30 Day Money Back Guarantee
-
24/7 Customer Support
AS FEATURED IN
Recommended By
Experts, Pros & DIYers
Our products are backed and used by professionals all around the world.
Our products are backed and used by professionals all around the world.
30 Day Money Back Guarantee
Frequently Asked Questions
A fork slides in from the side, so you only have to loosen the screw rather than take it all the way out. On a crowded terminal strip or a panel you cannot get behind, that is the difference between a two-minute job and a long one.
Crimp only. Strip the wire, insert it into the barrel, and crimp with a standard crimping tool. No heat and no solder are needed.
The colours are sized by wire gauge — red for the smallest, then blue, then yellow for the heaviest. Match the colour to your wire, and the fork width to the screw.
No. The nylon sleeve insulates the barrel and resists moisture and abrasion, but these are not a sealed connector. If the joint will sit in water or spray, use a sealed solder-seal connector instead.
A standard crimping tool is all that is required. No heat gun, no soldering iron.
Yes, provided the screw is tightened down properly. The crimp holds the wire and the screw holds the fork, which is why they are used in vehicles and boats.
Nylon, which stands up to heat and abrasion better than soft vinyl and keeps its grip on the barrel over time.
3–5 business days in the USA, and 7–10 business days everywhere else.
If you are not completely satisfied, we will make it right. Every SolderStick product is covered by a 30-day money-back guarantee, and our support team is there if you need them.